Konwertery CANbus - Quasar Electronics

Canbus converters

  • MCB02

    MCB02

    Module is designed for converting CAN-bus digital signals to single signals, corresponding to the individual messages which are transmitted to traditional car alarm without CAN-BUS input .

  • MCB03

    MCB03

    Module is designed for converting CAN-bus digital signals to single signals, corresponding to the individual messages which are transmitted to traditional car alarm without CAN-BUS input .

  • MCB-CLICK-J1708

    MCB-CLICK-J1708

    Module designed for contactless data acquisition from J1708. Thanks to this solution, the system reading the J1708 messages can be installed in vehicles without interfering with the factory J1708 installation.

  • MCB-CLICK-CAN

    MCB-CLICK-CAN

    The module acquires data from CAN-Bus or J1708 of vehicle without connecting it directly to bus wires. This solution provides safe installation of fleet management devices without the risk of vehicle warranty loose.

  • MCB09

    MCB09

    Module converts data from CAN-Bus of passenger cars to J1939 (CAN-FMS) standard used in trucks. Using MCB09 gives ability to acquire data and send it to fleet management GPS/GSM devices with CAN-FMS bus input.

  • MCB09-CLICK

    MCB09-CLICK

    Module converts data form CAN-Bus of passanger car to J1939 (CAN-FMS) bus. Module acquire data from bus without connecting it directly to wires and allows to send data to trackers which are equipped with CAN-FMS input only.

  • MCB10-RS232

    MCB10-RS232

    The Q-CAN MCB10-RS232 module is designed for translating digital signals transmitted over CAN-Bus. The MCB10 module is designed as interface to GPS-GSM monitoring systems or dataloggers which not handle the CAN signals but are equipped with RS-232 or UART port.

  • MCB10-UART

    MCB10-UART

    Module converts data from CAN-Bus of car to UART. Using MCB10 gives ability to acquire data (like: distance, speed, RPM (revs), fuel level, etc.), and send it to fleet management GPS/GSM devices with UART port.

  • MCB10-CLICK

    MCB10-CLICK

    Module converts data form CAN-Bus of car to UART serial port. Module acquire data from bus without connecting it directly to wires. Modules gives ability to send data to trackers equipped with UART input only.

  • MCB11

    MCB11

    The MCB11 module is intented to read and convert the digital signals transmitted over the J1708 and J1939 buses in Volvo and Renault trucks. Module works with the GPS/GSM/GPRS monitoring systems or trackers which are equipped with the RS-232 or UART port.

  • Bootloader USB

    Bootloader USB

    The interface which enables to connect the MCB modules and other devices to PC computer and change configuration or install new version of firmware.

  • Harnesses for Bootloader USB

    Harnesses for Bootloader USB

    The set of harnesses for connection of devices to Bootloader USB.

  • Bootloader MCB

    Bootloader MCB

    The compact interface which enables to connect MCB modules to PC computer and change the configuration or install new version of firmware.

  • Harnesses for Bootloader MCB

    Harnesses for Bootloader MCB

    Set of harnesses for Bootloader MCB for connecting devices to PC computer